Research Paper on Design a WLAN scenario and define
the topology where the WLAN will be used using opnet software
To order this Research paper, visit
A.
The Task
This
practical assignment involves you in the WLAN network performance analysis. You
are required to design a WLAN scenario, and conduct QoS performance analysis
under different traffic combinations, including data traffic and real time
traffic. This assignment weighs 100% of
the total practical assessment (i.e., the practical component of the overall
assessment).
You
will need to do the following specific tasks:
1. Design
a WLAN scenario and define the topology where the WLAN will be used.
2. Based
on your WLAN scenario, design 2 different traffic combinations, such as web
application, Voice over IP (VoIP), and FTP. Then discuss each of the traffic
combination, and state what you would expect from the analysis.
3. You
will then choose the performance criteria in terms of throughput (under IEEE
802.11 a/g/n), delay, latency and security (you can choose firewall and/or built-in
parameters of simulation tool). Choose 2
performance criteria. Discuss the reasons for your choice.
4. Setup
your simulation in OPNET.
5. Finally,
carefully design and clearly state your test cases, and answer the QoS
questions. The following steps may help you in designing your test cases.
5.1
Set up the first test scenario. For a
combination of traffic input types, test the network performance. You need to
choose meaningful performance criteria, such as throughput and delay. In your report,
you need to
a)
describe
your test scenario and chosen criteria;
b)
show
some relevant screenshots; and
c)
explain
and justify your results with variation of the curves obtained from the
simulation as shown on the graphs of the screenshots.
5.2
Set up the second test scenario. In
this case, increase the traffic input of the first scenario by 50%. Then, you
are required to do the same as the set of sub-tasks indicated in 5.1.
5.3
Compare and analyse the results you
have got in 5.1 and 5.2 and explain them.
B.
Deliverables
The
following need to be documented in your report for this assignment:
1. Description
of Tasks 1-2 (no more than 6 A4 pages, and no fewer than 3 pages).
2. A
diagram of your designed network
3. Your
test scenarios. Try to give critical analysis and clear explanation on your
test cases and results from Tasks 5.1 and 5.2 above. Also, show your
comparative analysis and evaluation (as required by Task 5.3 above).
No comments:
Post a Comment